亚洲精品一二三,免费看的av,久久久久久久极品内射,天天色天天爽

產品[

射頻信號發生器

]資料
如果您對該產品感興趣的話,可以
產品名稱: 射頻信號發生器
產品型號: TGR6000
產品展商: ZES
產品文檔: 無相關文檔


簡單介紹
射頻信號發生器TGR6000是10mhz到6000mhz頻率范圍的射頻信號發生器。

射頻信號發生器

的詳細介紹

Aim-TTi TGR6000 6GHz RF Signal Generator

The TGR6000 is a low-cost 6GHz signal generator intended for CW (carrier wave) applications where modulation is not required. Low phase noise is matched by low leakage, low residual FM and spurii. The internal timebase has a 1ppm stability, and an external frequency reference can be used. Sophisticated sweep functions enable the frequency and/or amplitude to be swept over the full range of each in a single sweep.

0MHz to 6000MHz frequency range
10Hz setability, +/-1ppm frequency stability
Locking to external frequency standard
-110dBm to +7dBm amplitude, 0.1dB steps
Fast stepping sweep with dwell times down to 10ms
List sweep of up to 1000 points of amplitude vs frequency
User compensation tables for specific test set-ups
Storage for 12 generator set-ups and 16 sweep lists
Compact half-rack 2U casing uses minimum bench space
Full remote control through RS232, USB, LAN and GPIB
Significantly lower cost than other 6GHz generators

Technical specification
Frequency  
Frequency Range 10MHz to 6000MHz
Setting Resolution 10Hz by direct keyboard entry, or in user-set increments of 10Hz to 999?999MHz by rotary control or increment–decrement keys
Phase Noise 500MHz Carrier: <-110dBc/Hz @ 20kHz offset; <-120dBc/Hz @ 100kHz
  3GHz Carrier: <-95dBc/Hz @ 20kHz offset; <-110dBc/Hz @ 100kHz offset
  6GHz Carrier: <-89dBc/Hz @ 20kHz offset; <-104dBc/Hz @ 100kHz offset
Residual FM Equivalent peak deviation for 300Hz to 3.4kHz B/W: 12Hz at 500MHz carrier
Settling Time <8ms to settle within 100Hz or 0.1ppm of final frequency, if greater
Reference Frequency Internal or External (via rear panel BNC)
Internal Accuracy +/- 1 ppm over 15°C to 30°C; +/- 2 ppm over 5°C to 40°C
Internal Stability < +/-1ppm/year ageing
Internal Ref. Out 10MHz from 50 Ohms, amplitude 2V pk-pk into 50 Ohms
External Ref In 10MHz into 50 Ohms, amplitude 2V pk-pk to 5V pk-pk
Output Level  
Level Range –110dBm to +7dBm (0.1μV to 500mV into 50 Ohms)
Setting Resolution 0.1dB (or 0.01μV to 1mV) by direct keyboard entry, or in user-set increments of 0.1dB to 100dB (or 0.01μV to 100mV)
Accuracy Better than ± 2dBm
Harmonics <-25dBc at +7dBm. <-30dBc@levels <=0dBm 30 to 6000MHz, <-25dBc@levels <=0dBm 10 to 30MHz
Sub-Harmonics <3000MHz : None. >3000MHz :<–40dBc (typ) @ +7dBm
Non-Harmonic Spurii <–50dBc >10kHz offset 10 to 3000MHz, <-44dBc >10kHz offset 3000MHz to 6000MHz
Output Connector Type N
Sweep Frequency and amplitude sweep
Step Sweep Step frequency and/or amplitude according to a formula over a specified number of points
Dwell Time Individually programmable 0.01 to 10.000sec per step
Max Points 1000
Sweep Run Continuous or single. Sweep up or down
Step Spacing Linear or logarithmic
Sweep Triggering Manual, Ext. signal, timed (0.1 – 999.9sec) or via remote interface
Sync Signal Output Stable) available during dwell time. Programmable as high or low
List Sweep As for Step Sweep except that a user defined table of frequency, amplitude and dwell time values defines the steps. The table can be created within the instrument or downloaded via the remote interfaces
Max Points 1000
List Storage Up to 16 Sweep Lists can be stored permanently within the instrument
Point Trigger Each point in a sweep (step or list) can be subject to a trigger event rather than a dwell time. Trigger by Manual, Ext. signal or via remote interface
Trim (User Level Compensation Tables)
Function A table of frequency/gain pairs allows the user to modify the generator output level with respect to frequency to calibrate an entire test set up or improve the calibration of the generator alone
Max Points 100
Interfaces Full digital remote control through the RS232, USB, LAN and GPIB interfaces
RS-232 9-pin D connector. Variable Baud rate 1200 and 115200 Baud
USB USB 2.0 connection. Operates as a virtual COM port
GPIB (IEEE-488) Conforming with IEEE488.1 and IEEE488.2
LAN (Ethernet) Standard 10/100 base-T hardware connection. ICMP and TCP/IP Protocol
General  
Size and Weight 2U (86.5mm) height; half-rack (213mm) width; 350mm long. 3.65 kg. (8 lb)
Power 110-240VAC ±10% 50/60Hz; 100-120VAC ±10% 400Hz; 60VA max
Approvals Complies with EN 61010-1 (Safety) and EN61326 (EMC)

隨附

Operating manual, driver software, power lead

產品留言
標題
聯系人
聯繫電話
內容
驗證碼
點擊換一張
注:1.可以使用快速鍵Alt+S或Ctrl+Enter發送資訊!
2.如有必要,請您留下您的詳細聯繫方式!


深圳市華瑞高電子技術有限公司    地址:深圳市龍華新區布龍路與龍觀路交匯處展?jié)櫳虅?wù)大廈702    郵 編:518133
電話:13316563358    傳真:0755-22142490    粵ICP備13037693號  

 

粵公網安備 44030902000433號

色偷偷噜噜噜亚洲男人 | 日韩亚洲欧美精品综合| 亚洲区激情区无码区日韩区| 亚洲一区二区在线免费观看| 饥渴老熟妇乱子伦视频| 日韩久久无码免费毛片软件| 欧美综合婷婷欧美综合五月| 亚洲av无码之日韩精品| 亚洲精品456在线播放| 免费的美女色视频网站| 精品亚洲欧美无人区乱码| 内射人妻无套中出无码| 精品无人区一区二区三区| 四虎影视无码永久免费无码 | 国产成人影院一区二区三区| 日韩人妻无码精品系列专区| 亚洲日韩一区二区三区| 日韩人妻无码专区精品| 久久久久久无码AV成人影院| 亚洲乱妇老熟女爽到高潮的片| 亚洲精品久久久久久下一站| 久热国产区二三四| 懂色aⅴ精品一区二区三区蜜月| 国产麻豆乱视频av380| 四影虎影高清视频| 四虎1515| 97青草超碰久久国内精品91| 人妻少妇精品中文字幕av蜜桃| 在线观看h| 日日摸夜夜添狠狠添久久精品成人| 中文字幕一区二区三区人妻| 四虎影视大全| 亚洲精品久久久久久桃密91| 欧美疯狂做爰3xxx高清| 四虎tv| 屯留县| 日本免费一区二区三区在线播放 | 91精品国产乱码久久久久久久| 欧美最猛黑人xxxx黑人猛交| 精品国产成人亚洲午夜福利| 超级碰碰碰97免费视频|